How to use
Skin straps are one of the absolute salon essentials. They allow precise and accurate preparation of the nail plate for further steps in styling. Thanks to them, you will easily and quickly get rid of unwanted skins.
Cuticle pins with a cutting edge of 5 mm and an 8.5 cm Mistero Milano handle are used by professionals to cut cut cuticles during nail styling procedures in beauty salons as well as in house conditions. If you're still wondering how to cut out skins we have a definite answer for you!
Mistero Milano skin cutees are made of high-quality surgical steel covered with a multicolored holographic coating that gives the whole a unique character, increasing the comfort of work. The pins are perfectly in your hand - ergonomic design and perfectly contoured handles ensure high comfort of work, the pins do not slip out of the hand. The product has a safe spring mechanism that facilitates the opening of the clamps and guarantees quiet operation and extended durability. Thin, sharp blade facilitates accurate and safe cutting of the epidermis.
Always use the cuticle pin before applying styling preparations to a thoroughly cleaned nail plate. Remove dry cuticles with a blade and cut off measuredly along the nail. Never tear off or pull the skins up as you will cause the customer pain or discomfort.
Skin cuticle pins are a reusable product. However, it is important to remember that each treatment takes place after disinfection or sterilization of the tool. Mistero Milano skin caps are suitable for autoclave sterilization.
The safety of Mistero Milano products is supervised by a certified team of experts on Cosmetics Safety and Household Chemicals. The information contained in the product card is accurate and true. However, the manufacturer is not responsible for the storage, storage, transport and misuse of the product. Mistero Milano products are intended for professional use by certified nail stylists. The manufacturer reserves the right to change the product specification. Product tones may vary depending on the production batch.
How to use
Cleaning and sterilization of tools
Rinse the tools under warm (not hot) water immediately after the procedure (preferably up to 20 minutes after the procedure). Then, before the sterilization process, perform a pre-cleaning, in one of two options:
a) Manual cleaning - use only delicate plastic brushes and neutral detergents (too low pH can cause damage to stainless steel protective surface and black coloring, too high pH will cause brown spots). After cleaning, rinse the tools thoroughly under running water, then let them dry and store in a clean and dry place.
b) Ultrasonic wasching - tools should be cleaned for a full, recommended cycle time - usually 5 to 10 minutes. Place the tool in the open position, make sure that the blades do not touch any elements. All tools must be completely immersed. Do not mix different types of metals (stainless, copper, chrome, etc.) in one cycle. After ultrasonic cleaning, rinse the tools to remove the cleaning solution.
Only clean, previously washed tools can be sterilized.
Insert the autoclave tools into bags designed for sterilization individually or in sets. Make sure you are using a large enough bag so that the tool can be sterilized in the open (unlocked) position. The recommended sterilization time is 15-30 minutes, at 121 – 132 °C.
Water and moisture of all kinds (especially blood, pus, surgical residues) are the main cause of discoloration and pitting. Another mistake is washing the tools with an inappropriate solution, e.g. bleach, iodine-containing and chlorhexidine-based solution or chloride-based solution. Be sure to store tools made of different materials separately (stainless steel, copper, carbon steel).